P
PrintablesJames
Teardrop Floss Drop (with tab)
My print settings: Material : PLA (with this design it's not the strongest) Infill: 100% (it's only 2g per tab) Ironing: on
- Pobrania
- 270
- Polubienia
- 27
- Ocena
- 5
Wszystkie modele
Liczymy pasujące modele…
P
PrintablesJames
UniFi G5 Pro Angle Mount
The UniFi G5 Bullet Pro camera has a mount that allows some angle variation, but it's limited - especially when mounting to a ceiling. This can be used to add some height/offset to the mount, and/or add some more angle. Fusion 360 file is…
- Pobrania
- 56
- Polubienia
- 4
- Ocena
- 0
P
PrintablesJames
Concealed AirTag Mount for Bike Rear Light Mount
Designed to be as un-obvious as possible to thieves, and attach to the rear light mount on a Kalkhoff e-bike without any modification or additional hardware. It should work on any similar bike with screw holes roughly 49-50mm apart. The…
- Pobrania
- 53
- Polubienia
- 11
- Ocena
- 0
P
PrintablesJames
Minimal corner cable channel
This 'cable channel' is designed to snap onto a cable (e.g. extension cord) running along the edge of a wall to make it a little more aesthetically pleasing. It's very minimal, and really just designed to tidy up 1 cable rather than…
- Pobrania
- 11
- Polubienia
- 0
- Ocena
- 2
P
PrintablesJames
Gridfinity 1x1 CR2477 Battery Holder
Holds 2x CR2477 batteries, with some misc storage space.
- Pobrania
- 3
- Polubienia
- 0
- Ocena
- 0
P
PrintablesJames
Light switch cover for Hager Silhouette
These are to stick over a Hager Silhouette light switch to prevent it being turned off when a smart light is installed - the goal being for these to blend in, and still have a way to remove them if needed. Printed at 0.08mm layer height.…
- Pobrania
- 1
- Polubienia
- 0
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.