Liczymy pasujące modele…
AICS Long Action magazine for 30-06 based cartridges. This is long action and will not work with 308 AICS rifles. Nor will it work with long action 300 win mag. There's not enough room to make the feed lips strong enough for 300 win mag.…
This mount allows you to mount an Akro Mills Bin to the front bar of the Hornady LNL AP press. Stock Hornady bins are the 30210 models. Bin Mount Sizes Single Double (about 75% support of each bin) Double Longer (100% support of each bin)…
This is a powder funnel and component separator that fits in the tube of the Hornady LNL AP progressive press. Print with flat side down and no supports needed. 2 walls 20% infill with filament of your choice.
There are several different castings of the Hornady LNL AP press. The older press has a more square bar and the new presses are more trapezoid shaped. There may be 2 different sizes of the clamps that fit the newer presses. The widest one…
This is a bullet/brass tray to fit the Hornady Classic reloading press. Print with 4 walls, 2 bottom layers, 3 top layers, 20-25% gyroid infill. With a 0.6mm nozzle you can do 3 walls. Supports are needed touching buildplate only to print…
This is a 2D Cell to 18650 battery adapter. Designed to fit into a 2D Maglite but may work in other applications as well. The negative side is where the washer goes and that's what contacts the spring on the Maglite flashlight. The…
I needed a better place to print from my filament dehydrator. So, I designed this to mount at the back of the Ender 5 and it provides a convenent place to mount the filament dryer. It can be adjusted for different widths of filament…
This is a powder baffle for the Hornady LNL AP powder dispenser. It has an adjustable flow feature to tune your powder throws for the different types of powder. Print with at least 2 walls 20-25% infill. Top probably needs 100% infill.…
I needed to raise the limit switch to work with linear rails. Print 2 walls or more 20-25% infill. Uses the stock limit switch for an Ender5.
Remixed mount to fit my Harbor Freight dial indicator with a 9.5mm shaft.
To wszystkie aktualnie dostępne wyniki.
