Liczymy pasujące modele…
A fast-printing plug to fit into an empty DisplayPort socket. Nothing special, just designed to print relatively easily. You'll want to print this as oriented in the .stl, with the non-notched short edge on the build plate: this gives the…
This is a top and bottom for a bare 5.25" floppy drive such as the TEAC FD-55GFR. It is almost certainly compatible with other TEAC FD-55 drives, and likely with other floppy drives of the same vintage. (Note of course that the 5.25" is…
A small shelf designed to hold the MikroTik CRS305-1G-4S+IN switch in place and connect to a server rack. There are small pegs to hold the switch in place: it is a somewhat tight fit, but the switch can be set atop the pegs and slid…
This is a simple bracket that can be printed as a half-height bracket for single-port Mellanox ConnectX-2 PCI cards. This is a remix of rasarmg's “PCI Bracket Generator” on Thingiverse , and is only a very small addition to it. If you…
This is the tenth iteration of coasters I've designed, and the best by far. It is designed with several properties I thought were important: It takes condensation off of cups / bottles / etc. as it drips down, keeping them from dripping…
Main Piece This item includes several options for mounting your Lutron Aurora Philips Hue dimmer. Lutron sells a “L-AWALL1-WH” plate for mounting (intended to mimic a “traditional” switch that the Aurora can mount to natively), but this…
This includes two ways to replace a teenage enginering OP-Z battery. The 3D printed version was developed fairly quickly with a tight deadline, so I was unable to fully refine it, but the end result works fine even though it looks a bit…
Overview This is a simple mount for a Logitech C920 (sometimes called a “C920 HD PRO” or other names) to hold it on the upper corner of a Prusa XL. The mount is surprisingly stable with just two magnets, and it fits in the inside corner…
This fits 20-each of 12 different grit sanding papers plus two different back plates and pads, as supplied in the kit I ordered . I printed up labels for either side to label the grits, but didn't want to mark up the model to embed them…
A simple adapter between the TINY PUMP 2X and a 30mm diameter port. The 30mm port appears to be moderately common for some adapters and air mattresses, including the EnerPlex camping air mattresses . The fit on the TINY PUMP 2X end is…
Overview These feet are intended to be slipped directly over the existing feet for a Prusa XL printer, and over 1" diameter Sorbothane discs to dampen the vibrations from a Prusa XL. It appears moderately effective, although some larger…
This is a tool intended to mount on the arbor of a hole saw, inside a larger hole saw, to allow you to drill a larger hole centered on a smaller one. (Normally this is more difficult because most hole saws are designed with a pilot drill…
This is just a simple rail-style holder to keep Akro-Mils Akro-Bins (sometimes punctuated “AkroBins”) hanging on an IKEA SKÅDIS board. You will want two (identical) pieces for each bin: one actually has the bin hook onto it, while the…
This is a pair of cases for ZBiotics Pre-Alcohol ($20 off referral link). The glass vials are probably relatively fine on their own, but glass seemed a bit fragile and sometimes I want to take several out to share, so I drafted a…
To wszystkie aktualnie dostępne wyniki.
