Liczymy pasujące modele…
Case for my Floppy Emulators from Big Mess of Wires, done as a pastiche of Macintosh Platinum to match my SE/30. Everything pops into place, then hold together with 3mm screws (thread the Case_Top posts to catch them, i used 8mm long…
this is my pass at a shim to reinforce the 1400’s Display Housing / Hinge. I am not an engineer, just a hobbyist; please feel free to remix & re-share. the complex lower profile is to fit around existing structure, using those pieces as a…
this rack holds ziplock bags by their zipper. The slots are .15mm wide, with a little bump on the inside-outer edge to maintain tension. This is for 5"x7" wide bags, but could hold smaller. The design is very minimal, to keep print times…
Replacement I/O Door for the back of PowerBook 180. (Might fit other models, let me know; i only have the 180.) Use this to replace a missing door, or remix into a custom version. Share & enjoy. I printed from PETG; the little side pegs…
the PowerBook 180 case interior is intriguingly minimalism. There is very little actual structure; some components are held in place simply by being stuffed into the case itself. The hard drive has no sled, or even screws—only two tiny…
This is a model of the battery for a Macintosh PowerBook 1400. It fits the existing battery bay, and includes the appropriate slots to align and latch into place. I am not an engineer, just a hobbyist. You can print an entire battery and…
This is a model of the original hard drive mounting bracket inside a PowerBook G3 (Wallstreet & PDQ, c. 1998). I modeled this to make a variation (to mount and SSD and some other pieces in the existing bay). The original has a slightly…
My powerbook was missing one foot, so i decided to replace both. There is a tiny ridge on the “inside” to facilitate snapping in place, so print with support whether you print face up or face down.
To wszystkie aktualnie dostępne wyniki.
