Liczymy pasujące modele…
v2 of the cutter Unclip drag chain and remove bowden tube. Slide cutter under the drag chain slip over drag chain mount and insert bottom of cutter into bowden hole on print head. Reinstall drag chain and insert bowden tube into top of…
All in one. Print in place. Qidi Q1 Pro bed leveling tension knob v2. Every inside tick is 2 minutes. Every outside tick is 2 minutes. Total of 60 minutes. I've also updated the screws_tilt_adjust macro so it probes a reference point in…
The Qidi Q1 Pro SLYCR2 filament cutter for the Qidi Q1 Pro. This version the body is a one piece slimmer design. No need for supports, I have easy to remove supports built into the model. Just simply twist the support and they come right…
Sort and organize your ptfe tubes and tool head cable
This is designed to activator the manual filament cutter and mount the switch for the 3dChameleon. It can also be used to activate the manual cutter using gcode and not use the 3dChameleon. Orca Slicer Setup Click on the printer settings…
Qidi Q1 Pro bed leveling tension knob. Every inside tick is 2 minutes. Every outside tick is 2 minutes. Total of 60 minutes. Has access for a nut driver to loosen and tighten the lock nut. I also find it easier to change the…
A bezel for the display
Easily remove the ptfe tube from the print heaf
Designed to be used to reach the extruder adjustment inside the coPrint chormahead.
a replacement spool holder for the flashforge creator 5. this is for the front holders. mirror on x axis in slicer for rear added v2 - adds spool retainage ring to printer side
Mount the coPrint KCM module on the Neprune 3plus/max and 4plys/max models. You will need to replace the screws with longer screws
While installing LED's on my Flashforge 5M I noticed that the LCD ribbon cable was extremely close and possible even rubbing on the y belt pulley and after running the wires for the LED's I felt it would be better to put a spacer in the…
A 3dChameleon switch mount for the Qidi Q1pro. May also work with other Qidi printers. Mounts vertical above the rear left motor. Use 1 small screw in the center mount hole to secure switch to mount. X,Y location is x=0, y=245. switch…
A replacement bracket for the nozzle blockers on the flashforge creator 5/5pro
A more compact extruder for coPrint. It allows for the extruders to be mounted tight to each other to fit more of them in the same space.Was made for use with coPrint but can be used for other extruder purposes. BOM: BMG internal parts M3…
Cover the face of the 2020 excursions on the delta flyer refit by Rolohaun
An alignment jig to align the linear rails on the delta flyer refit if you install the corner panels first.
An easier to grip handle
1 solid top inner panel that has mounts for the mellow fly 5dp and pi zero w2 from the original delta flyer.
A remix of the carriage to fit MGN9H rails
An addon for the x and z belts of kappy to allow easy belt claming.
To wszystkie aktualnie dostępne wyniki.
