P
PrintablesShaggy
U2C mount for 2020
All you will need is: x4 Voron standard heat set inserts x4 M3 30mm 2x M3 Tnuts 2x M3x8
- Pobrania
- 24
- Polubienia
- 5
- Ocena
- 0
Wszystkie modele
Liczymy pasujące modele…
P
PrintablesShaggy
Ender 3 V3 KE 5020 Fan mount
This is a shroud that uses a 9500RPM 5020 blower fan. Just uses 3 screws and thing runs amazing. I just reused the connector from the stock fan that went on the KE. Link to the fan:…
- Pobrania
- 22
- Polubienia
- 5
- Ocena
- 0
P
PrintablesShaggy
2510 Fan Replacement Cover/Shroud
Ayyooo, so I made this to fix a fan that broke right where the motor holds onto it. So i designed a new one! All you have to do is make sure you have some sort of CA glue or something to glue the motor in the center of it. Thats all! If…
- Pobrania
- 22
- Polubienia
- 6
- Ocena
- 0
P
PrintablesShaggy
BIQU Nebula Mount Adapter for Yavoth
This is made to easily adapt your new Biqu Nebula extruder onto a Yavoth toolhead! To install, Slide in the button top screws into the orbiter mounting holes **BUT DONT SCREW IT IN YET** Then you can place the Nebula on top and screw it…
- Pobrania
- 14
- Polubienia
- 9
- Ocena
- 0
P
PrintablesShaggy
Fysetc CAN Disto Board Toolchanger Backpack Base
All you will need for this are 10 M3 voron standard (M3xD4.6xL4) heat inserts and 10 M3x6-8 screws. I would use button top. ** If you want to use just 4 of each (1 for each corner) instead of using all the holes for inserts and screws,…
- Pobrania
- 7
- Polubienia
- 2
- Ocena
- 0
P
PrintablesShaggy
BTT Ducky motor mount
All you need is some glue and you're good to go! If you want to add hexagons, go to the color painting and use the "fill" option. Check the fitting of the piece that goes over the motor shaft to make sure it fits right. Adjust the size as…
- Pobrania
- 5
- Polubienia
- 2
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.