Liczymy pasujące modele…
This is a Gridfinity stand for the TS100 / Pinecil soldering irons. IMPORTANT: This uses the Strong Stand by Termiman . The base uses the Gridfinity Refined design, so you can press fit magnets in to the base, rather than requiring glue.
The original is great and the creator was kind enough to include an F360 file. I adjusted the angle of the holders to 15 degrees for my own personal convenience. I also closed some of the holes on the bottom so it would print cleaner and…
This holder holds the 1.5, 2, 2.5, 3 and 5 WERA hex keys. These were the ones I used most often and wanted a way to keep from setting them down on the table during a project, often getting misplaced.
This is a Gridfinity holder for the Measure & Sort Tool by Sneaks .
This is a holder for Wowstick bits, meant to fit in to the Gridfinity organization system. It uses magnets to hold the bits in place, but has material between the bit and the magnet, allowing the magnets to function, but not be so strong…
Allows you to use the EasyBRD in the ERCT electronics box, which is currently only available for the Biqu MMB
After printing and using the Skadis Brother P-Touch Label Printer Holder by baconschteam , I wanted to mount my cartridges so they were in the same place. This holds 4 tape cartridges. The 3 pegs on the back make this a little tricky to…
I have a bunch of these NTE 24 AWG wire spools and thought I'd make a Gridfinity holder for them. I chose to do single spools because sometimes I only need one or two at a time for a project. This is a single part and you just need to…
To wszystkie aktualnie dostępne wyniki.
