Liczymy pasujące modele…
This is for the Voron 2.4, I moded Akio's design to allow for cover to fit the Z rails placed as per the Voron build guide. In the guide the Z rails are spaced 3mm above the lower frame extrusion. I just added a notch to fit. The design…
BLTouch Mount for FLSun QQ Delta printer. You will need 3 M3x10 screws to assemble and 2 screws from the BLTouch kit (or 2 M3x5) to mount. Run a M3 tap through the holes in the top plate and the two holes in the bottom piece. If you dont…
Based off of the numerous wedge designs already out there. I needed a low profile wedge to help level out the warped heat bed on my Ender 3 (low in the middle). Print 2 so you can have one on either side of the thermistor pad. Sand the…
This is a simple mount to hold a dial indicator, used to help tram the bed. (or to show how warped it is) Can be used with the Petsfang2 cooling system. This will mount with 2 M3 x 20mm screws to the std 40x10mm extruder cooling fan. Dial…
Remix to change inner mount pt to 33mm spacing for HK 28-35 Propdrive v2. Outer mount pt is still at 44mm. Cut-outs are for M3 hex nuts. (5.5mm side to side) Std M3 nuts will fit flush but nylock nuts will be a little proud of the…
I was tired of the limitations of the MKS TFT display so I wanted to get a standard LCD for access to the menus. I did not want to reinvent the wheel so I used this case from ZilDV . Remove the MKS TFT from the QQ and install and assemble…
Z endstop adjustable bracket for Misumi 2020 extrusion. Used on an Eclips3D printer. Update: Added 2nd slider with more adjustment length Remixed to add some stability. I tightened up the tolerances to decrease wobble between the bracket…
Smaller effector plate for the Dreammaker OverLord Pro & non pro. Centers the nozzle and should get a print diameter of 180 ~190 mm on the OL Pro. It uses the stock 60mm rod spacing on the sides so you don't need to replace the OEM…
Dress up your Eclips3D with these corner covers. Hides the end of the extrusions and the corner bracket and gives a more finished look. Extrusions are Misumi 2020 and using the Misumi corner bracket (HBLFSN5-C) with the threaded screw…
Just Another Delta Calibration Adjustment Thing. I wanted a test object that took a little less time to print. Many thanks to Dolpin for all the great tuning instructions. Original Thing http://www.thingiverse.com/thing:745523 Outside of…
This is a caddy that will hold a Philmore 30-2400 Micro snap action switch. (available at Fry's in the US) Switch should press into a cutout on the bottom of the part. It also has a groove for the wires to exit. Caddy will temporarily…
Modified the Front Rod holders to add a cutout so that it will be easier to align the Y axis Rods. The current design has a hole in the front brackets that you must insert the rods into. This puts inward pressure on the rods making them…
On the Overlord and Overlord Pro, wires can chafe against the metal shield around the top of the hot end. This object protects the wire bundle from the sharp edges of the shield. Print Settings Printer: Overlord Pro Rafts: No Supports: No…
To wszystkie aktualnie dostępne wyniki.
