Liczymy pasujące modele…
The Cricut Maker has had a problem ( on some units ) where the roller on the paper hold down bar will migrate off the edge of the cutting mat. This will cause the cut to fail. The details are in the reddit link below. The net of it is…
As DrZzs call this; Jumper Holder Thingy Some of the new Sonoff Basics ( and probably others ) are being delivered with solder filling the serial programming interface. So if you want to flash it, you need to either remove the solder or…
I wanted to test reading NTAG213 RFID cards, so looking through the internet, I found the schematic to connect a PN532 card to an Arduino Nano using the SPI interface. With code available thru ebay, I have a functioning card reader.…
UPDATE. DO NOT USE. The user tested out this clip and the S31 board is too loose to have stable connections on the pins. Without an S31 device to use to model, I cannot correct this. See comment section ......... Sorry. A user requested a…
NEW VERSION FAN DUCT.............................. HE3D K200 is a good delta, but is slightly different from the 'standard' kossel based machines. As for the kossel, I am using the mini kossel as defined here (…
The HE3d K200 has a small piece of acrylic that mounts to the corner frame and receives the adjustment bolt. The design leaves a little to be desired. While this modification is not perfect ( a better one would probably attach to both…
I decided to install TLSmoothers on my Anycubic Predator and I really really liked SolidRye's Anycubic Predator TL Smoother Holder here-> https://www.thingiverse.com/thing:3794073 . I ordered my smoothers ( I like TriangleLabs products…
Made https://www.thingiverse.com/thing:9325 , but noticed the bar clamp had about 2 mm of extra room in it. I created a new look-a-like, but removing 1.5 mm of that space. This goes with thing 9325 and the rest of those parts are required…
On my davinci jr, I replaced the Bowden feeder and mounted it outside the unit. There is a filament sensor that is in the stock feeder that I wanted to keep. I also wanted my Raspberry Pi to be mounted inside the unit so I created this…
To wszystkie aktualnie dostępne wyniki.
