Liczymy pasujące modele…
I made this because I messed up my follower for my Hexmag, and for some reason, no one's made the design yet. I made it for the 5.56/.223 magazines. I have tested it and works great. The magazine ejects properly and the bolt catch also…
California compliant stock and forward grip blocks to make a P-90 compliant. The one in the pictures is a Ruger 10/22 in a High Tower Armory 10/22 P-90 stock kit. It should fit on an actual FN P90/PS90. (rimfires aren't considered an AW…
This are files to make the M10 wire connector to fit the "M57 firing device." The connectors inside are made from a female spade connector cut in half. Solder wires to the tail of the split connector, and insert. Holes might need…
This is a trigger spacer for the High Tower Armory stock kit for a Ruger 10/22. Normally, the HTA trigger would have a lot of travel before it touched the real trigger. With this spacer, it greatly reduces the slop in between the fake and…
Folding High Tower Armory 90/22 charging handle. I used a threaded insert on the base, and screws on both sides to affix it. Also a random torsion spring.
This is my copy of the stock High Tower Armory 90/22 charging handle. Some parts aren't exact.
Added a linkage system so that the launcher can be attached a bit more secure. Also changed the grip part so that other grips can fit. You can install 2 257mm rails screwed together for sights and rigidity, recommended but not required.…
This is a copy of the Time-to-Change magazine follower, aka Maklarbak magazine. The idea of this forgotten tech is that the follower will lock the bolt open before the last round is fed, you then drop the bolt and reload with peace in…
Basic dovetail mount for anything. I was using this to hold a filament box. Very loose tolerances.
JE Machine SOPMOD Stock Storage Tube. Mirror the Cap model in slicing software if you need the locking stud on the other side.
Flower support for 3 flower stems
ULine "H-156" tapegun wipedown blade replacement 2x M4 6mm Heat Inserts 2x M4 10mm Screws
needs x4 M3*12mm screws and x1 M3*4mm screw for the power switch lever
Replacement clip for the 48-22-1906 Milwaukee Fastback
Copy of the front plastic wheel for Toyota palletjack HPT28U
Glue stick holder that mounts to horizontal 20x20 v-slot rail. Uses a M3 8mm screw and a rotating nut.
This is a replacement of a Uline tapegun tension Knob, with M6x1 threads
This addon allows for very quick reloads for M72 law 37mm projectiles. Connect your round to the primer holder via tape match or alike, and load into the primer holder w a 209 primer into the primer housing. After closing the latch, you…
Basic model of a pull-tab balloon light.
This is a spacer that goes in between magnets when replacing old M57 magnets with neodymium magnets. Two are required.…
This adapter allows you to fit 3in core mini wrap rolls on a Goodwrappers 1.75in core dispenser.
To wszystkie aktualnie dostępne wyniki.
