Liczymy pasujące modele…
Fits 70mm drains, allows for good flow even when partially blocked. Should be printed with heat resistant filaments if its going to be exposed to boiling water, I found that PETG and ASA will warp, while PC is able to resist warping with…
Effervescent tablet holder that fits the standard 29mm diameter tubes. The optional TPU base should just seat into the slot and hold well without glue, although the fitment quality can vary depending on your printer and slicer setup, so I…
All parts can be attached to the original multifunctional arm without reprinting anything. The softer attachments on the base and clamps should prevent damage to the arm mounting surface as well as provide extra grip. The phone holder…
Replaces the integrated plastic tab that commonly shears off, allowing the fog light to be secured without replacing the entire bumper. The bracket replicates the factory slot geometry. Once bonded, the fog light housing slides into the…
Three piece ramp that connects with dovetails. Each piece at 242mm length, would need to be printed diagonally 1 or 2 at a time on smaller printers.
To wszystkie aktualnie dostępne wyniki.
