Liczymy pasujące modele…
I made a keg washer using plastic conduit and bought a ½ bsp die to thread the ends to connect everything together. While it was possible to turn the die by hand it was hard to keep it perpendicular to the pipe. This holder maintains the…
A remix of the parametric card box from Skrallex https://makerworld.com/en/models/618970-customisable-playing-card-hard-case-openscad#profileId-542867 Configured to fit the cards from Mantis, and then embossed using BambuStudio
A cover for the wires of a HX711 load cell based set of scales used as a keg scale for Cornelius kegs and mini-kegs. This is inspired by the instructables post https://www.instructables.com/Beer-Keg-Scales/ The hx711 and related circuit…
To try and avoid plastic waste we try and reuse plastic bags as often as possible. These need drying, and need to be held open so that the air can get in. I tried some other models that I found elsewhere, but felt it would be improved if…
A lid for the jug for the milk frother so that it can be put back in the fridge. With the frother head on it does not fit well in the fridge door.
A plate to close off the top of a Keg King Junior or Chubby fermenter to keep it clean. This is modelled off of the dimensions of the original lid. V1 does not have a groove for an o-ring, it is not intended to be a water-tight seal, more…
This is a narrow spray nozzle I created to use with a home built keg and fermenter washer. I have a stainless steel ball head but it does not fit inside my 8 litre Kegland Oxebar kegs or 10 litre stainless steel kegs. This is a female ½…
To wszystkie aktualnie dostępne wyniki.
