Liczymy pasujące modele…
This is a remix of my pop-up monkey hook and AwesomeA's sloth bust. However, because sloth's aren't known for their 'popping' I've also added a bit to allow the the sloth to ease up and down. I've also swapped out the tail for a leg…
Inspired by old cast pulleys this is a modular pulley system intended to be decorative, stackable, and for use with paracord. A 8x22x7 mm skate bearing should press fit into the center of the pulleys. 5/16" or 8mm bolts are used to hold…
See the video for assembly instructions and print orientation is shown in the video and the build plate photo. My take on the pop-top hook mechanism. No supports and everything slides or snaps into place. I made it so the design for the…
This tool is based on my favorite trash pick up tool that is basically just an extra long set of tongs. It does well at picking up a variety of item sizes. To try to maximize strength and rigidity this is not a print in place model. Print…
Small propeller/frisbee that can be fun to play with. Powered by the flick of your finger. May need to scale based on hand size. You want the center hole to be close but not a tight fit to the tip of your finger. The model is sized to me…
These are wheel center caps that I made for my dad's minitruck. Made for a 60 mm center hole, if you need a size modification for your specific wheel shoot me a message and I can probably make that happen. Print flat side down, no…
The trip lever mechanism in my tub corroded and stopped working so I spent entirely too long and too much filament iterating through designs as a replacement. I printed in PETG with enough wall perimeters to make the latch flex arms solid…
Three wise monkeys by Cathy29 sized and trimmed for pop-up monkey hook . Yes, I know they are apes and don't have tails, but still cute I think. Haven't tried printing them yet, but it looks like they should be able to print without…
To wszystkie aktualnie dostępne wyniki.
