Liczymy pasujące modele…
This is a cable clip for a 4080 simrig to hold the larger cable sleeve. It clips onto the rig and stays put. Very small and fast to print so you can print several to help you guide the cable sleeve around your rig.
This simple holder will clip into a 4080 groove and will help support any device. I use it to keep the PSU in place (check photo) and the larger one to keep the portable keyboard.
This “Yet Another Smartphone Holder” is supported by sliding and fitting over the screws, not being screwed in. This allows for a more shallow profile and therefore a smaller holder.
This print allows to you run cables (power, USB, audio, ...) on your profile and keep them hidden. Both versions clip onto the rig slots, no hardware needed. It is very generous in space as I had a lot of cables to run. You can print…
You can add haptic feedback to the Simagic P1000 Pedals using the official peripheral or you can DIY by using some relatively inexpensive components. You'll need: Nobsound USB Amp (about 45eur at the end 2023) two “resonance speakers”…
To wszystkie aktualnie dostępne wyniki.
