Liczymy pasujące modele…
The 3MF file includes organic supports and support blocker. Just in case the 3MF is weird, just block supports on the hole for the light guide (I used a piece of clear filament and superglue).
Be careful with the support material, as blocking the slits will make it painful after printing. I used paint-on supports to support the 2 ends of the thing and the very edge and blocked support near the actual slit so that it wouldn't be…
NOT MY MODEL, ORIGINAL MODEL MADE BY https://www.thingiverse.com/GromMaker. Original description: Bracket allowing you to secure your Fiio E10K to a desktop using two small screws. It slides in with a slight interference fit, but can be…
Print it in this direction, the slight dropping will add some friction to hold the card into place. For pictures, see this make of my original post on thingiverse: https://www.thingiverse.com/make:846485 .
Fixed version of the buckle, will update this summary once I try to print it. Edit : Worked, supports are a bit finicky to remove and you have to be careful with the 4 little bumps, by cutting around them beforehand with a knife. Print…
Front and back clip for 2 cables
Remix of SuperFrodo's magnetic detent for the TWCS throttle. Made for 2 5x5x5mm magnets that you can get for cheap on AliBaba. Update : The cheap Alibaba magnets aren't enough make it even slightly "grip" to a position, it depends on the…
Coffee stencil with the StonX FBT system logo on it. https://www.stonxvr.com/ (I am not affiliated to StonX, but I highly suggest you go check them) Category: Kitchen & Dining
Adapter to use Tundra trackers or other ¼" 20 screw mounted stuff on VUT mounts, for example body straps or gloves. You'll have to use springs, around 5 or 6mm diameter. You might have to put some foam at the bottom of the adapter,…
To wszystkie aktualnie dostępne wyniki.
