Liczymy pasujące modele…
Labists ET4 firmware!! Was a pain to find, had to go to Facebook and message a support guy. So here it is!! https://drive.google.com/file/d/1wXhCY1h7tXundF53bnfL9ESNWKrbd4Bc/view?usp=sharing Category: 3D Printer Accessories
Just a bigger one, and one that has been made into a keychain! Very simple. Category: 3D Printing
This is a custom made Protogen head! It will fit most heads, as long as you make the straps to attach it long enough. It fits a 5" screen on the inside, has a pen hole slot on the front for a raspberry Pi camera, and slots for LED…
So, this has my Logo on it (cause i sell these with tails) but its basically a sewn-on attachment that goes on the base of the tail. Once on, you can run a belt through it, and through the middle belt buckle for wearing. Print Settings…
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/dkzWdVPPuTD Use the four smaller holes for bands connected to a servo motor, to wag the tail. middle hole is for metal wire, to allow the tail to be semi…
Hello everybody!!! This is a design in continuation of my open sourced Protogen head project!! I've been in the furry community for quite a while now... and the biggest hurdle in getting a suit or even a partial is the lack of skill, and…
Just a Latin II project. The top part is the duct itself, with a 1-degree slant on the middle section of the aqueduct and a 1-degree slant on the bottom to promote water flow to the bottom part, which would hold the pump and extra water.…
To wszystkie aktualnie dostępne wyniki.
