Liczymy pasujące modele…
I had some extra pc parts laying around, so I decided to design an open-air frame and assemble a working pc. The mother board dimensions are approximately 245mm x 245mm (micro ATX). I printed the mother board mount with the base facing…
This mail tray stop to keeps mail envelopes organized and from sliding around in the tray. I have printed and tested this model. The original version was uploaded by themadjem
I updated my Ender 5 Plus to direct drive and needed something to organize the direct drive wires. I used an existing hole and a small wood screw to attach the mount. This wire holder probably works for all the other Enders with similar…
This is an extended print cooling duct for a Flsun QQ-S. I designed this duct to fit with a V6 Volcano hot end. I recommend printing in PETG or ABS. Place the flat side of the duct on the bed for easy printing. Supports aren't necessary.
Phrozen Shuffle XL exhaust vent. The vent is designed to receive a 4 inch dryer hose. The internal fan on this printer is plenty strong enough to efficiently push air though the hose. I printed this part with supports from the build plate…
Heart bookmarker. Print with the flat surface on bed. Us whatever filament you want
Air tubing mount for 6.3 mm OD or 1/4 inch OD air tubing. This version holds 4 lines. Mounting holes are counter sunk for dry wall screws. Print the mount sideways for strength. No supports
I designed these feet to lift the printer to increase air flow to the control board. The feet raise the printer about 18 mm. These feet also help reduce vibrations. There are two different feet available. One requires removing the old…
The mount uses existing holes on the X axis gantry where the thin metal cover is mounted. The camera is an inexpensive DIY camera from amazon. The camera holds well to the mount without a fastener, but you can use a small screw to attach…
To wszystkie aktualnie dostępne wyniki.
