Liczymy pasujące modele…
My mom said the original was a bit slippery so I added the ridges on the sides. I printed it with 40% triangle infill, no top/bottom layers, and 5 walls.
I glued these 20 pieces (4 per side, 5 sides) to a 10x10x10 inch cardboard box. The eyes are painted purple and are mesh so you can see through them. I used black duct tape for the box corners; I'm sure there's something better to use.…
In the original model, if I squeezed the handle too hard I could pinch the blade which prevented it from moving. I added a back to prevent that. Make sure your flow is spot on or you'll have to sand the handles to get the blade to not…
This adapter is compatible with the Briss Fang cooling duct with 4020 and/or 4010 axial fans. Also works with a 5015 with an adapter but it's a tight fit.
The hole is 58x58x58 mm but the outside is the same size, to fit the original lid. This gives about 1 mm on each side of the cube and makes the walls real thick.
The dual gear extruder has the tubing adapter 10mm higher, so I moved the motor mount over to compensate. Other things adjusted: Added a hole to be able to adjust the gear tension spring Moved cable chain mount over and up a bit to…
remixed to be pointier, wider, and thicker. my wife says these changes make it easier to hold the book open.
I printed it upside down which makes the spot where the phone sits kinda ugly, but it used less support and had more bed adhesion that way. Also you can't see any supported surface when the phone is on the shelf anyway. The third picture…
The connected feet make it easier to print.
To wszystkie aktualnie dostępne wyniki.
