Liczymy pasujące modele…
ryobi workshop blower nozzle, remixed to bit more gradual. I use to for blowing grass off my golf cart during early and late season rounds. print upright with no supports, should print fine, needs at least 160mm z height.
ClicGear 3.5+ Clip for range finder holder, makes sure the range finder is the right height and available when you need it. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 0.16 Infill: 80%…
a remixed outer ring for the gimbal from universal travel coffee gimal model. this fits most clicgear cart using its mounting pegs on the side of the cart. print on its back and it should print without any supports.
precision pro ranger finder holder that clips on all clicgear golf carts. print upright and enjoy. intended for the left side of the cart for a right-hander, assuming the cart is on the left side of the ball when you go to read your…
Ender 3 - Stealthbruner X carriage for MGN12C linear rails. The originial has holes for full MGN12, this is for a MGN12C. Moved the holes around a bit, they are 15mm instead of the 20mm of sepratation they are the same distance apart in…
Remixed to match the mount of the Micro Swiss Direct Drive Extruder for Creality CR-10 / Ender 3 Printers. https://store.micro-swiss.com/products/micro-swiss-direct-drive-extruder Nice and secure mounting under the heat brake, I applied a…
With a Trident printer, headroom is limited, and the umbilical needs extra space to function effectively. To address this, I remixed a few G2E extruder designs and created two mounts: a swivel mount on the toolhead, which currently pivots…
Thurstmaster HOTAS wtih Airbus Detentes. Idle/rev idle, CLB and FLX. To match Airbus throttle stack.
A 30 degree wedge for a dome camera, when mounted to a wall to change angle a bit more. The dome camera base needs to be about 110mm in diameter, and holes are 120 degrees apart. I printed without support in ABS, but other should work…
A remix to hold a cheap AliExpress filament runout sensor, this mounts where the extruder used to be, since I moving to a direct drive. Setup. As of now this needs to printed w/ supports. I will try and redesign it with no supports. Just…
This is Foscam C1 mount for Teaching Tech's camera mount system. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: Doesn't Matter Supports: No Resolution: 0.08 Infill: 40% Filament: AMZ3D PLA Notes: Straight forward print.…
To wszystkie aktualnie dostępne wyniki.
