Liczymy pasujące modele…
Fits the HOLT5202BJ2 drawers perfect when printed with PLA While you could rotate 180 degrees this assumes you want no gap on the front drawer edge Since there is limited Z clearance I chose the minimal baseplate so they are staggered to…
This was designed for a Mikrotik CRS326-24G-2S+RM but Im pretty sure all of the 1U Mikrotik devices use the same pattern
Designed for the ISW-504PT but likely fits their other models that share that form factor Print with PETG if this will be used in a hot environment
My rig has enough holes in it so instead of drilling more I made this. Sized for PETG Bolts are M3 anything between 7-12mm should work, #6 should work as well The tension fit comes from the 4 "bumps" (shown in the last pic) that protrude…
Sized for the Makerfocus 3000mah pack but probably fits others of the same spec Sized for PLA Uses the screws included with the enclosure/plate kit Antenna slots are sized for the included bluetooth with the adhesive strip and paper intact
An insert for the 158x90x60 low cost outdoor encloure on amazon found here Currently fits the RAK19003 node, but the insert was intended to be modular so I will add more in the future Uses M2 Threaded Inserts Sized for PETG The drill…
To wszystkie aktualnie dostępne wyniki.
