Liczymy pasujące modele…
It can be printed out of PLA, PETG or any other non-flexible material. Use the outer brim, .2-.12 layer thickness, and slow down the first layer. As it is a print-in-place model, you'll need a well-calibrated printer. After printing, cut…
I printed it out of PETG, but any non-flexible filament will do. It uses four pieces of 10x2 neodymium magnets. I attached six versions for different paper sizes and left and right pen holder orientations. In the pen holder part, this…
Printing tips Print the gliders' base with high infill (60-80%) because it also acts as a balancing weight. Use variable layer height and print the curved bottom surface as low layer height as your printer reliably can. 0.12mm will do,…
The model is self-supported if printed in the orientation shown in the photos. After printing, drill the inner hole with a 3.5mm drill bit, then tap the hole with an m4 tapping tool. After that, remove the support and add an M4x16 hex…
To wszystkie aktualnie dostępne wyniki.
