Liczymy pasujące modele…
Covers for the front seat rails BMW partnumber is: 52109110104 and seem to fit multiple year/models. Print the model with the thicker part on the printbed to support is needed. The fit is pretty tight so you will need to fiddle a bit. The…
This is a drop in replacement for the Deebot Omni X1 station sink. This is the part that sits in the back of the sink and prevents the dirty water pump from sucking up debree. I intent to put some fine mosquitto net on the inside of this…
Replaces the original Ender 3 PSU cover to use a 120mm fan Mount fits a 40 extrusion with a bit of overhang Uses the original PSU switch Fanmount needs to be glued to the PSU cover
Solid state relay dimensions Width: 44.5 Height: 61.8mm
Simple mop holder to store the Deebot X1 Omni mops when not in use. The holder can be pushed into the handle on the back of the base station. It consists out of three parts which need to be superglued together. Use some painters tape to…
Y Axis stepper mount for 2040 extrusion. Requires: The original stepper mount from the ender3 y-axis Bearing, you can get one by cutting up a spare extrusion wheel Two M5 heat inserts Two M5 bolts Two M3 bolts This fixes the problem where…
Based on the original design Outside diameter 112mm Needs support for printing
Wallmount for the outdoor Brennenstuhl extension cord
Needed an AirTag holder for my cube ebike, there wasn't as specific one for my e-bike: Cube Supreme Hybrid Deluxe One. Is a press fit into the front fork suspension.
Wire constrain for the ender extender 400 with a CR-10 S4 heatbed. The original wireconstrain is from the ender extender team, i couldn't find the original one here. I've redesigned the part especially for the CR-10 S4 bed. I recommend…
Replacement hinge for the Black and Decker dustbuster dustbin
This device was fixed with some cableties which caused some ratteling behind the right lower dash. This bracket is mounted on the side and requires four M3 screws to replace the original screws. Please be awere of the screw length, else…
My iPhone 13 Pro Max didn't fit in the original phonemount so i made a drop in replacement for the original ones. The ‘rubber’ parts are printed in soft TPU, i've printed the wing in PLA. I Should fit a phone 16MM thick with casing. The…
To wszystkie aktualnie dostępne wyniki.
