Liczymy pasujące modele…
Canopy for the Voron 2.4. Will need to be printed with supports, corner for fan will need to be mirrored for one side. Will work with 250, 300, & 350. Will use the standard acrylic top panel. Spots for 60mm fans with spacing for charcoal…
For those that use the canopy in my other files or some other variant with similar middle (will work 250, 300, or 350), this mount will allow you to attach your ERCF v2 on top. There is a new End Bypass with channels to run wiring under…
Been working on this for a while on and off, pretty much has been working great for my setup. I had to change the files some to work for the standard bed layout for the 350mm 2.4 since my bed sits lower. Its also made for a 355mm and can…
Made these to go with my Voron 2.4 Canopy, but should work on any 60mm fan. You will need 2x A332 or any similar 9g Sub-Micro MG Servo, I used Spektrum A332 & A332R(Reversed) servos. You will also need 8x MR85-2RS(5mmX8mmX2.5mm) ball…
So you wanted a place to put your 5in screen up higher or your Voron 2.4. Now you can if you have my Voron 2.4 Canopy. Will need a BTT HDMI5 V1.2 with the cables coming out the back. You will also have to remove the speaker on the back by…
To wszystkie aktualnie dostępne wyniki.
