Liczymy pasujące modele…
I made this mount for my Ender 3 but I have also used it on my other non-ender printers. It has a Raspberry Pi camera housing and a generic mount for a 1/4" camera mount that I mounted a Logitech USB camera on. There is a Raspberry Pi…
This is a case I made for some hex bits I purchased. The cases they came in were all broken. I still want to try and add the bit sizes.
2x608ZZ bearings will be needed. They are 8x22x7 bearings that would normally be used for skateboards. Like these…
This is a case I designed for PI KVM setup that has a feature for a DB9/Serial port for routing GPIO out of the case. No hardware is needed, it should snap together. Updated the front/bezel part as the feature that holds the HDMI-CSI…
I needed a way to mount my X52 flight controls to my gaming chair. This may not work for you. I used 1" aluminum pipe from Home Depot. Screws for the project are M5x20 with M5 nuts. Use electrical tape or some other rubber-type material…
PPE face shield for a baseball cap. Category: Other
This is an elastic band clip to use with the NIH DTM face shield to use in place of buttonhole elastic. Use 1/2 wide elastic. Category: 3D Printing
To wszystkie aktualnie dostępne wyniki.
