Liczymy pasujące modele…
Top mounted filament spool holder. Used for printing TPU on a K1 MAX. The adapter rings are a press fit into the original side supports to adapt them to fit standard cartridge bearings. The spool roller should be a slip fit into the inner…
*** Update *** I added internal baffling to the manifold to even out the distribution to the 10 outlets. I was using a soaker hose to water my garden, but I found it had a few shortcomings. I was watering areas between my plants that did…
Tired of squeaky belts? This little adjuster gives you easy leverage to adjust the angle of the tensioner pulley, while tightening down the screws, to align it to the drive pulley. This will allow the belt to track in the middle of the…
A simple boot to fit a Stanley Iceflow 30 oz. cup Protects the bottom edge of the cup from dents if dropped. Prevent damage to softer wood surfaces or breaking glass tabletops. Print from TPU of your choice. I used standard 95a at 100%…
Print thread side up. No Support needed. Only works with older style Yeti Can koozie that has the full turn thread. Does not work with the newer slim version with ¼ turn threads.
I needed a featherboard with more reach for my router table, so I designed this one.
80 tooth 1.5 module spur gear. 35 mm bore diameter with circlip groove to retain a 11 mm wide bearing. Overall thickness of 19 mm. This is a replacement idler gear to drive the power feed / threading gearbox for an Enco 110-1351 lathe.…
Use to hold these hygrometers securely in the filament roll when storing in vacuum bags. https://a.co/d/a6vdoKm
I was not happy with the factory oiling solution for the power feed / threading gearbox on my Enco lathe so I designed this. All oil ports are now in one location and sealed from chips or debris. I doubt anyone will ever need these…
To wszystkie aktualnie dostępne wyniki.
