Liczymy pasujące modele…
The gas bottle holder diameter is 74mm, because this is for my work van I needed it to be strong due to the movement of the vehicle so the infill was set to 40% (print time 31hrs) But this can easily be reduced if it were to be fitted to…
When the headboard keeps banging on the wall, simply fit two of these to the back and adjust the knob to tighten the board. You can either stick one side to the wall with 3M tape, or just place it on the back. In the closed position the…
Just a simple sanitary towel dispenser. Category: Bathroom
Just a simple mount that stops the air vent grills from dropping under the weight of a regular phone mount. Then using a magnetic phone mount bought from eBay stuck to it with 3M tape. Base dimension: 50x50x10mm Hooks 26mm…
When installing 100mm or 125mm (4"- 5") featheredge/closeboard panels this spacer will give you the required 25mm overlap between panels. Category: Tools
This remix has a wide opening so it doesn't need any support, and the mounting bracket is wider to make it easier to screw to the wall.
Increased the height by 7% to allow the threads to fit freely, also if you use a little silicone spray it works a treat
35mm internal diameter Category: Kitchen & Dining
This mount can be attached to the dash using 4mm or 5mm hex bolts, washers and nuts, just unclip the dash surrounding the speedo. Once you have printed the mount, glue a magnetic mount (similar to the one in the link bellow) to the print.…
To wszystkie aktualnie dostępne wyniki.
