Liczymy pasujące modele…
Hex nut sorter V2 Now including a fully customizable parameterized .scad! Let me know if there is a size you'd like added. No supports needed. Enjoy! What is it? A device for easily sorting all those hex nuts your kids dump all over your…
Check Out the new and improved V2 here ! I'm happy to make other sizes if there is interest.
I just resized JellyTitan's SmartThings model to fit the 2nd gen Philips Hue Bridge.
I designed this post-it note holder to store 2 3"x3" pads in the back and a few in the front for display. It stacks nicely on top of this stencil. Because it stacks, it prints best with some support on the bottom. If you aren't going to…
Can't decided if you should buy a new printer? Get out your decision maker!
I wanted to make something with moving parts for the machine competition. This design works okay but needs to be precise, especially the separator piece. It works (maybe even better) without the catching bin and clips. I made a more…
Simple model, no supports. I think it should hold up fine with any filament. I printed it at .3 layer height 20% gyroid infill in PETG I printed the version with the bigger holes. The side with the holes closer to the edge will face the…
The line above the number signifies that the nut is the max dimensions. The line below shows it is the min dimensions. Machine size #3 shows |3 instead of 3 to differentiate it between M3. This model was built in Openscad, I will post the…
DeWalt 40v Max charger wall mount plate. My charger is a DCB114 that came with an edger. I printed it with a .6 nozzle and added a 100% infill modifier around the screw holes. Probably not necessary but that's what I did.
I will update this later with the hardware sizes and settings I used. I printed it in PETG. Not sure how other materials will hold up but this has been working great for us.
The cover and the base can be printed at the same time even with color changes.
Home networking 8x3 24 port patch panel. A long 24 port panel was too long to fit between the studs in my utility closet so I made this. I used the panel here:…
Replacement battery door for the Honda Pilot rear entertainment system remote.
Remixed to take off the hanging hook and add some screw holes to permanently mount this on the wall.
Pretty self-explanatory I think! It printed best for me with the AirTag hole facing down and a little bit of support. It worked without supports but best with a little support. Make sure to install it with the drain hole facing down!
This case holds an AirTag and a clamps around a power or extension cord. There are 2 versions one that presses together and one that screws together with m4 screws/nuts. You could glue the one and loctite the other if you really wanted…
To wszystkie aktualnie dostępne wyniki.
