Liczymy pasujące modele…
This is a DN40 pipe clamp that is snug tight. I use DN40 pipes for the vac in my workshop. I printed it in PETG and PLA. Orientation with clamp tower upwards and clamp tower sideways are possible, but sideways seems a bit more robust.…
This mounting bracket is designed for the Elfin EW11 and to be screwed together with cheap din rail clamps . I use the holder to mount the WIFI - RS485 (Modbus TCP - RTU) converter within my sub-distribution cabin and to read values from…
This is a booster for a heating radiator because the forced airflow increases the efficiency of the radiator and more heat can be transferred to the surrounding air. (NOTE: If you have a heating energy measurement device sticking on the…
A towel hook for radiator rods with 24,5mm diameter and increased distance from hook to radiator so that the towel does not cover the radiator too much (seems to be good for the efficiency of the heating radiator). The edges of the towel…
This is a strain relief for cables with a diameter of approx. 73mm. Two M12 bolts are used to tighten the clamp. For a test i printed it with 30% gyroid infill in black PETG. I is a reverse engineered design (see the piccture - original…
This is a gridfinity baseplate for IKEA Alex e.g. with article number 594.222.20, 004.735.46 or 904.861.39 width a total width of 36cm and a drawer width of 30cm. The baseplate parts were generated with the scad files from…
This is a case for a pizza cutter that is stored in our cutlery drawer and damages the insert. I designed it to prevent the scratches in the cutlery drawer insert. I printed it in PLA and works fine for me. The blade fits perfectly.
I made this wallmounted 2€ coin collecter to present my collection of special 2€ coins. Display can be mounted with 4mm srews. The base can hold up to 5 pieces in x asis directly beneath but some more may be mounted with an overhang.…
I designed this license plate holder because the original holder has only one mounting bracked and was a bit wobbly, so that after a while the holder broke off. Should not happen again with two mounting brackets. The clamp has to be…
This is a compartment that can be attached to the headboard (square tube 32mm) of a camping bed. I printed it in two parts. Clip in black PLA and compartment in glow in the dark PLA and glued it together with cyanoacrylate glue…
To wszystkie aktualnie dostępne wyniki.
