Liczymy pasujące modele…
This improved version is designed to prevent the filament from falling off the roller when the filament material is exhausted and to roll well without resistance. Some parts of Multiple Mechanism Auto-Rewind Spool Holder have been…
I updated the Shaft and Nut in addition to improving the Sunlu Dryer I made previously. You can check the improved Sunlu Dryer from the link below. https://www.printables.com/model/247479-sunlu-dryer-s2-mod
Printed using a tree support. Wiring was done as follows. Cut the red line from the 4pin cable and connect it to the COM and N.C of the limit switch respectively. The AMS will switch off automatically when you insert external filament.…
I upgraded the Prusa Mini to THK LM and Direct Extruder while doing Bear Mod. I secured the one-armed shortcoming of the mini, and secured Bowden's shortcomings with a direct extruder. This is a modification of the baer mode base, so i…
I share model files used for mini bear. Some of the MK3s Bear models have been modified to fit Prusa Mini. https://github.com/gregsaun/prusa_i3_bear_upgrade Please refer to Prusa Bear Github for assembly instructions.…
The IR Sensor of Prusa Mini works in the opposite way to MK3S. I modified the IR Sensor to operate in the opposite direction based on MK3S+ Extruder. If you are interested in the Zaribo extruder mod, check out the link below…
It is designed to mount a USB extension cable on the side of the LCD box. Inserts were purchased from the site below. The insert specification is M3x5.0x4.0.…
It is a plate attached to the front of the Mini bear.
Orbiter v2 is applied to the direct extruder used in the Prusa Mini Bear. The tube length used in Dragon Hotend is 32mm and the E3D v6 is 48.3mm The front of the e3d v6 tube should be beveled at a 45 degree angle. If you use the ADXL345…
Modified the Orbiter sensor housing to allow the use of the Prusa mini filament sensor with the Orbiter. Magnets are square 5x10 Sensing lever uses m2 x L8mm Ball Size : D6 Note: Be sure to swap the 5V and GND positions of the filament…
It is a plate attached to the front of the Mini bear. At people's request, I modified the text to be centered.
To wszystkie aktualnie dostępne wyniki.
