Liczymy pasujące modele…
The original cleaner is one of my favorites, but I didn't like the way it was Just hanging on the filament, so I merged it into UBBI, which is also one of my favorites. Uses a 6x2mm magnet.
An adapter that converts a special battery for the PSO-1 into two LR44 batteries. Two LR44 batteries are not long enough to reach the terminals on both sides, so a 3x6mm aluminum or copper rod is glued into the hole in the battery…
The optical filament sensor is good, but it cannot detect transparent filament (as described). When printing with transparent filament, need to use the stock sensor, so I mounted it like this. I know there is already has a nice mount for…
I'm sure you could design something better, but anyway it works. Bottom Bowden fitting may not be necessary.
This is a killflash and cap for the TE211M, secured with shock cord, based on One Hundred Concept's ScopeCap/LightCap/ShockCollar. The rear cap and collar for the…
Killflash & picatinny mount adapter for GUIDE TE211M And mount base for RMR footprint red dot I think you know where it came from Required Hardware T1 / T2 style red dot base M3 screws and nuts 3mm or 1/8-inch shock cord Mesh material for…
NVG10 Wide-Angle Lens MOD Adapter. Replaces the standard lens with an M12 IR CCTV lens. I used a 5MP lens with a 6mm focal length, but it may also be compatible with 3MP lenses. Printed with 0.1mm layers. It might be a bit tight. Mine fit…
To wszystkie aktualnie dostępne wyniki.
