Liczymy pasujące modele…
For display in your office or workshop, a flat area to store things. I set a 10mm socket inside for a maintenance department joke, everybody had a good laugh. For the clear "glass" I used 1/16" polycarbonate sheet cut to size by making a…
I created this as a test and proof that certain features are working correctly. There are a million of these tests out there, however I wanted to include a 45 degree wall to test if VFA was present with just one XY motor turning.
Simple test to verify the squareness of the gantry. When printed and carpenter square used on it, the square should touch at all points, if there is a noticeable gap, you may need to adjust the tension on your gantry It is meant to be…
I had an issue with "pg-front-case-R3" where the outer ring on the cover didn't match up with the planetary gear shafts and because of that, the nextruder gearset was able to push out about 3mm and cause the filament not to feed…
Santa's sleigh candy dish designed to stay within build area of Core One and MK4S. Skis are designed in a half dovetail to be easily printed and slid into the back of the sleigh Can be done on XL as a single print skis should be printed…
Save your finger nails from bamboo torture (filament torture?) -- print these scrapers. I usually print a few at a time,
This funnel is to assist with reusing resin for SLA printers. It accepts filters similar to https://www.amazon.com/Printer-Disposable-Strainer-Recycling-3DMaterials/dp/B099Q1WFSQ and other similar filters. It can be used to filter out…
To wszystkie aktualnie dostępne wyniki.
