Liczymy pasujące modele…
I need to model a backpack proof case for my Logitech MX Ergo, therefore I needed to scan it. Here's the STL, maybe it's of use to somebody. I have only made a rough scan, didn't get all the crevices and cleaned it up quickly in Blender.…
I need to model a backpack proof case for my Logitech MX Ergo, therefore I needed to scan it. Here's the STL, maybe it's of use to somebody. I have only made a rough scan, didn't get all the crevices and cleaned it up quickly in Blender.…
The silicon mount of my dog tracker broke, then the hooks on the side of the case started breaking as well and as I had to scan it anyway in order to design something around it to hold it properly again I though I might as well just…
This is a quick replacement for the broken silicone strap on my dog tracker. It clamps the tracker against the harness. As the hooks on the case started to give up as well, I decided to make a design that doesn't use them, hence, this…
A bottle dryer that mounts to any standard 80mm computer fan using 4 M3 bolts. The bolts screw directly into the 3D print (no inserts needed). Print without supports in the bolt holes for better thread grip. Accommodates bottles with…
15° ceiling mount for Samsung HW-K650 / HW-K651 soundbar (and possibly other Samsung soundbars with an 88mm deep casing) that attaches to the original mount points. Requires two M4x30 screws and ideally two 4x12mm washers for the mounts…
I needed to model a flap cover for my Type 2/CCS charge port, so I scanned it. Here's the STL, maybe it's of use to somebody. I've only made a rough scan and did minimal cleanup in Blender (just alignment). The area behind the open flap…
scan of Audi A2 with AUA/BBY, engine bay outer frame, engine block hook alignment of the scan is along the upper fender mounting plates, not absolute ground.
Kleiderbügelaufnahme für Türrahmen die man entweder hinter dem Türrahmen einklemmen oder mit einem halbierten Stück Patafix aufkleben kann. Funktioniert für alle Bügel die ich in meinem Haus gefunden habe. Druckbar ohne Support mit…
This is a quick and dirty scan of this router: https://openwrt.org/toh/cudy/x6 Should be good enough for anything related to mounting one of those.
Dies ist ein konzeptioneller Nachbau des kommerziell verfügbaren "Klebenagel" von der Marke mit dem kleinen t. In die sechs Einbuchtungen auf der Rückseite passt jeweils genau ein 10mm * 13mm Stückchen weißes patafix. Drückt man die…
Ich benötigte einen Referenzscan der Ubiquiti UniFi G3 Flex (UVC-G3-FLEX) für den Entwurf einer eigenen Halterung. Es handelt sich um einen groben Scan: Nicht alle Vertiefungen sind perfekt erfasst, und er wurde nur schnell in Blender…
To wszystkie aktualnie dostępne wyniki.
