Liczymy pasujące modele…
3030, 3535, 4040, 5050 Gasket Kits for Convoy flashlights with a 9mm reflector hole. From the left, the first centre piece suits 0.9 & 1.0mm outer pieces, the second centre piece fits 1.0 - 1.5mm outer pieces. From the left: 0.9mm, 1.0mm,…
The bottom hole for the SBT90.2 is 10x11mm, so make sure you place it correctly. PLA not recommended due to 50°C heat deflection temp, starts softening. I use ASA for 100°C HDT, but PETG should be fine for 70°C HDT. Use white colour…
7070, 5050, 4040, 3535, 3030 Footprint. Height 0.6mm - 1.0mm. PLA not recommended due to 50°C heat deflection temp, starts softening. I use ASA for 100°C HDT, but PETG should be fine for 70°C HDT. Use white colour filament. 0.08 - 0.1mm…
The stock gasket is 0.3mm too small, making it almost impossible to centre the LED. This gasket centres the SFT25R perfectly. Recommend white PETG or ASA filament.
The bottom hole for the SBT90.2 is 10x11mm, so make sure you place it correctly. PLA not recommended due to 50°C heat deflection temp, starts softening. I use ASA for 100°C HDT, but PETG should be fine for 70°C HDT. Use white colour…
PETG or ASA recommended for higher heat resistance. Supports required The two rear screws need to be shortened 2mm or buy some the same as the front. The clip can't be used Use adaptive layers for best results on the curved surface Note:…
To wszystkie aktualnie dostępne wyniki.
