Liczymy pasujące modele…
2 Hairbands with diameter around 40mm are needed. Attachment system inspired by Kitty Ears for Razer Kraken. Print: -0.5mm Layer -need supports Probably would suit better an Over-ear Headphones, because of how huge those ears are.…
A "fancy" 2-part knob. A single-part version is also included. Printed with PETG, layer hight 0.2mm.
Tested on Fujica AX and Porst CR cameras. Was made specifically to unscrew the film advance lever screw on Fujica AX cameras. Should be printed with 0.4 line width.…
Utilises 20mm coutersunk m3 screw and a m3 T nut. T-nut can be printed. Needs stock bed holders as it uses them as supports. Ideally should be printed with Heat resistant materials (mine are made from PETG). This design should fit stock…
Not done, but i dont think i would be able to finish this. Hinges use 1mm OD metal rods, paperclips work quite nice for that purpose. To install the sidepanel with a 2g servo: 1. Attach the horn to the sidepanel with a U-shaped bracket 2.…
An Effector (with optional direct drive modification) for Threaded V6 hotend from Trianglelab. The spacing between magnets is 45.4mm to match those carriages. Magnet diameter should be 12mm, height: about 3.5mm. Glue is required (CA for…
I might have misunderstood how the board is supposed to be installed into the case, but it always had some space left between the housing and the screen (for the the acrylic sheet). I did not have any acrylic, so made a spacer instead.…
To wszystkie aktualnie dostępne wyniki.
