Liczymy pasujące modele…
A new one piece blade holder has been uploaded. Print on edge with supports. same direction as STL Version # 2 of the Handle has been uploaded. It has slightly rounded edges. Print at 100% infill with support. All you will need is some…
This Dart Case was influenced by https://www.thingiverse.com/thing:3314601 The Lid is held in place with a toggle, latched with a piece of 1.75 TPE. This case fits steel tip darts from 140mm to 155mm in length and up to 7.25 mm in…
360 degree Dart Board light. This has been designed to be used with or without a surround. The top LED Ring has been split into 4 parts for a printer with a print surface of at least 300x300. It has also been split into 8 parts for a…
Slingshot ammo clip that holds and dispenses 12x 3/8" (9.5mm) steel balls. There are two holsters, one that the clip faces to the front and one that faces to the side. You will need one 5/16" (8mm) diameter 1.8mm thick rare earth…
Fits 50mm thick Cubicle walls Print Settings Printer Brand: Creality Printer: Ender 5 Rafts: No Supports: Yes Resolution: 200 Infill: 50 Filament: PolyMaker PLA Notes: Print at least 4 perimeters Category: Office
UPDATE: Magnetic Version uploaded! for "rare earth magnets" 3mm thick and up to 9mm Diameter Monty Python Ministry of Silly Walks, Silhouettes for office cubicle window. Print Settings Printer: Mingda Rock 3 Rafts: No Supports: No…
Version_2 Uploaded! The body is in one piece. A gripper to hold your broom, mop, etc. It will hold from 19mm to 32mm (3/4" to 1-1/4") I used PLA and TPE Use a soft TPU or TPE. I tried with a harder TPU although it gripped it didn't…
A simple Mug Tree/Holder that holds 6 mugs. Just add a little bit of Super Glue at each part.
I printed these with 0.4mm Nozzle @2.8 Layer Hight 6 Perimeters 20% infill Printed with Strong Hero Galaxy Black and Supply 3d PLA+ White I printed these 10 degrees Higher than normal 215degrees. PS: Only a small amount of support needed.…
Print “Shade_Lamp” in Translucent PTEG. Print with “Vase Mode” I used an 0.8mm nozzle 0.4mm Layer Height 1.0mm Line Width 2.3 mm base Print “Top_Lamp” in PETG. Glue to inside top of shade. Print “Holder_Lamp” in TPU will probably work…
The main box can be printed in parts, (Shown in the pictures). Or it can be printed in one piece I printed this using a 0.6mm nozzle with 0.3mm layer height
Organizing cups that fit in "Azure Film" Spools. Designed for Vase Mode "L Pill Azure cup stl" design was from https://www.thingiverse.com/antonin_nosek/designs https://www.thingiverse.com/thing:2966470 "L wavy2 azure cup.stl" and "L…
To wszystkie aktualnie dostępne wyniki.
