Liczymy pasujące modele…
There are some tick removal tools in internet. To be honest there are quite a lot of them. You can also buy one. Anyway I was not satisfied with any of them (at least with that I have tried). So I have made my own model from scratch…
Stock camera configuration in QiDi Q1 Pro 3D printer causes unnecessary image quality degradation because of LED light falling directly to camera lens (at least if you have the same Q1 Pro version as me, because I can see that QiDi…
This is a safety pin to use in crocheting or knitting, when you put your work off and want to avoid damaging it. I made it for my wife. Works fine when printed with PETG, it is more elastic than PLA. Please better print it slowly to…
This is a door handle for the QiDi Q1 Pro printer, which is known because of a missing handle. So why to complain? Better let's print our own :-) This one is quite comfortable IMO but also quite visible at front of the printer. Use any…
If you print in PLA probably you want to take off a sprinter upper cover. I have designed simple rails to put that cover into. In my opinion it looks well and is quite usefull. Goog luck :-)
I made this part a year ago for somebody in my family. Unfortunately I have only one photo of that part (I will do more if only had a chance). Anyway it works till now :-) Support has been added to the model, do not need to add any in a…
This is my idea of replacement rolls. I made it quite a long time ago and still use at home. It is not perfect but usable :-) Rollers must be made in TPU. Shafts might be PLA, better make pins with something more heat resistant (PETG,…
OK, I know that there are quite a few dog bags holders on Printables. But I missed one important feature among them - when you pull bags out usually it is not very convenient to roll them back into the container. Here is a holder with a…
I designed this simple holder for the original brush to ensure it is properly stored and ready for use. The model has been printed using white PETG filament, as its color matches the vacuum cleaner housing well. But PLA would be good as…
This is a simple cap for a HPA connector
I have created it for comfortable moving micro SD card from a 3D printer card slot to a PC reader and back. Now I have both readers on my printer's front. Made in PLA without supports. The reader has been inserted to its hole with a small…
I had an insecticide (powder, granules) and needed a container to leave in something for a few weeks in a kitchen. So it is. Worked.
This is a simple model. First I considered it as a hanging gadget (v1), later redesigned it a little and added version without a hanger (v2) and finally redesigned once again and made it larger and with a higher border - as a beer (or…
I have a great, nice flashlight Sofirn HS42. But the grip might be better. So I have used my 3D printer to do it. Features: Nice feeling in a hand Easier and faster finding a good grip with tour hand in a pocket A flashlight can be put to…
This is a replaceable cap for a kind of bottle
I made a replaceable part for a gasoline water pump. Made from PETG works fine, ABS ora ASA also would be good. PLA not recommended because of the temperature. That part is necessary for starting an engine. Works fine, does its job.
To wszystkie aktualnie dostępne wyniki.
