Liczymy pasujące modele…
This U profile supports gives you the possibility to better cable management especially for the Sculpfun laser engravers like S9 or S30. It attaches the cable chain (20X10) to the frame legs so all is kept together when lifting the frame…
Printing Remarks. Best to be printed at about 30% for all parts except the very small ones which are on actual scale (in my case 30%) The reason behind this is that the programm I use for drawing is setup a bit strange, when I draw…
This is my design of the TS1 screen bracket for use on the Sculpfun S9 (or other models) laser. Layer 0.2 Support Yes Need some M4 or M5 screws and T nuts too
On my sculpfun S9 there is no way to switch a 230 volt air assist nor do I have a 12V type because of the fact that on an upgrade of the laser it would need a ne air assist because the voltage is different. I designed a simple relay…
This switchbox is designed to make it possible to choose wether you use the rotary roller or the (honeycomb) bed for engranving or cutting. This way you don't have to everytime pull the plug from the Y motor risking broken cable or…
I made this limitswitch to avoid little grabbing fingers get to my limitswitches and damage them. No need for screws or whatever, just clip them on, you can even keep the cable plug in place.
A low poly cover for your x axis motors on your Z9V5 printer from Zonestar. There are 2 versions, one as a whole and one in a split version so you can slide it on without having to remove the Nema stepper motor from the assembly.
Designed in Fusion 360 Just put on a big pant and started drawing in Fusion 360, after the 9th version I was satisfied with the endresult.
To wszystkie aktualnie dostępne wyniki.
