Liczymy pasujące modele…
This is the best way I could figure to mount a O4 Lite camera in a standard 14mm camera slot on existing frames. It won't work for all but should be a good stop gap until better is designed and new canopies are out. The weight with the…
This is a custom bezel designed for thr R7 series Dell rack mount server. This has been cut to fit the length of a small bed such as the Ender 3 The retention system is still untested but shoud work well enough. Possibly a minor bit of…
Many toothpick canopies for a 14mm camera are not suited to the up front bulk of the o4 (lite) camera so I designed this canopy to work with my o4 mount ( https://www.printables.com/model/1147195-dji-o4-lite-14mm-camera-mount ) providing…
You will need to mirror this to print both sides. The camera mounting plates are replaced as are the front stand offs due to the camera being too wide. The small tabs that lock into the frame will need filing until you are happy with the…
APC SMC1500I Bezel 2x M3x20mm bolts required to piece the front together. I tapped the PLA to thread into and it's plenty strong enough. I've yet to get around to filler/paint but the body of this is good enough to share for others to…
I made this for a family member last year. I'm listing most of this from memory, there is information missing but if I don't post it now this will sit in drafts for another year. Any questions please feel free to ask and I will do my best…
***Updated*** Magnets are no longer needed, friction fit only! The magnets were cumbersome for some switches due to the thickness causing the magnet to sit on the plastic over the screw and rock/wobble/feel loose. Beefed up the walls for…
MG10XU stand - allows for standing the mixer in a more upright position. Print Settings Rafts: No Supports: No Resolution: 200 Infill: 20 Filament: PolyMaker PLA Category: Audio
Speaker Stands to fit desk cable management holes (80mm) Holes included in the bottom and back both at the top and near the bottom to route cables. Speaker base 165 x 155mm Be mindful of "Hole Horizontal Expansion" when printing the…
I built the Cetus X into an Apex 2" frame, never used the goggles and my main radio is an RM Boxer so the case was destined for the bin, but it's a little good to just waste so I cut the liner out and made my own for transporting some of…
To wszystkie aktualnie dostępne wyniki.
