Liczymy pasujące modele…
I've created replacement parts for the Jobo 1500 and 2500 film development tank system. This collection might grow if I need more spare parts, but so far I've got four kinds of center cores for the film spools as well as a replacement lid…
You can order the collets I used here .
Supports: No Resolution: 0.0977 or 0.1954mm layer height (multiples of the thread) Notes: If you're printing in ABS, make sure to account for the shrinkage. Post-Printing Screw in the lens carefully for the first time to make sure you're…
My early 2015 Retina MacBook Pro (13 inch) still works great, but the display broke. Instead of getting a replacement display, I went the cheaper route to attach an external monitor and use it as a desktop computer for my kid. Some call…
On the Scheppach DC100 the inlet blows straight onto the motor assembly and clogs up the filter. I wanted to change the direction of the inflowing air to get some cycloidal action going. Angling the 100mm hose would require a much bigger…
This magnetic wall mount / desktop stand integrates with the Anio 6 charging cable. The tolerances are tight, so if you print this in PETG, rescale the model to about 100.3% to account for shrinkage. You need 12mm/3mm flat round magnets…
Print with the writing facing down. Add supports to the end of the 4 overhanging tabs - or just use the attached 3mf file which already has this supports configured. To screw it on your lens, align the external indicator line with the red…
This github project (not owned by me) provides the firmware for a camera shutter tester, running on an ESP32 board. I created 3d models for both a laser/sensor mount jig and a controller box that are compatible with this project. The jig…
Follow the instructions of and use with the stem and plate parts from the original Soldero model.
I didn't like the floppy rear lens cap that comes with the Fuji TCL-X100 tele conversion lens, so this is a twist-in lens cap.
If you lost the original one, you need a M5 bolt, preferably with a 10mm diameter head.
Helps keep the dust inside the grounds container of my Graef CM800 coffee grinder. Might also work for other models.
To be used with Scythe For Cosplay by Awesome Will I recreated the diamonds for the sides and designed a top-mounted diamond that you can slide into the center hole.
Print with automatic supports and pull them out with pliers.
This lens is really prone to reduced contrast from stray light, so I made the hood a bit longer. I only tested this on the Leica Thread Mount (M39 thread) version of the lens. This slips on the outside of the lens and holds on with…
To wszystkie aktualnie dostępne wyniki.
