Liczymy pasujące modele…
Created this Wago 221 holder to hold 2 terminal blocks so I could run my bed wiring to these and then to the mainboard. Lets me disconnect things easier and keep the electronics bay cleaner. Print with whatever you like how you like, just…
An all-in-(almost)-one solution to mounting your SKR Mini E3 v3 onto a DIN rail, while giving you the most headroom. I'd recommend a 40% infill of either line or grid pattern. It's a bit fiddly to install but if you put the m3 screws…
LRS-350-24 Terminal Cover - Voron Edition - Designed for the Mean Well LRS-350-24 used in the Voron Switchwire. It even lets you more safely tweak the voltage adjustment without fear of tapping a hot terminal. Print it however you like.…
About: * No need to remove your bed to install this mod! * After failing to print the McKurt Y tensioner mod a ton of times, I set out to make my own version that could be printed flat on the bed without any dramas. This is not an edit or…
LRS-350-24 Terminal Cover - Voron Switchwire BOM Compatible Edition - Designed for the Mean Well LRS-350-24 used in the Voron Switchwire. This is an updated version for anyone building a BOM Voron Switchwire, added notches to allow the…
NOTE! You may need to scale the model up about 1-2%, I designed it with very tight tolerances. New v2 Version! Now includes a larger cut face, and a hole where you can put an m5 bolt thru along with a t-nut to clamp the guide onto the…
This is designed primarily for cutting the 2020 x-gantry extrusion on the Ender 3 when performing a coversion to the Enderwire. This can be used for similar 2020 extrusions where you will be cutting it by hand using a hacksaw or other…
Print it how you like, I used 40% infill, lines pattern. To use insert the tube partway past the cut line, and cut using a razor blade (to square up the tubing) then insert the tubing all the way to the end stop, and cut. Repeat until you…
There are two variants - one is for if you don't use the bottom panel to enclose your electrics bay, and the flat top version if you do use a panel to close off your electrics bay. I used 40% infill with line or grid pattern. If you use…
This print allows you to mount your Ender 3 screen to the left side of the printer by screwing it into the side of the 4040 extrusion. I printed with 40% infill with grid or line pattern. Requires some m5 bolts and t-nuts.
To wszystkie aktualnie dostępne wyniki.
