Liczymy pasujące modele…
Wanted a little waste bin thing for under my desk. Gonna try this. First time I've printed anything in vase mode (actually not true, I did a Sierpinski Pyramid ages ago, but it's hardly the same thing) didn't realize how flimsy they are,…
I know these are a dime a dozen on here, but I didn't like any of the existing ones. I wanted one with the slimmest border possible, that holds the remote snugly, but still allows it to be slid free with a single finger… Check, check and…
Nautical themed coasters set of 4. Too bad I missed the contest. I used some left over insulation foam for feet. I recommend not using anything thicker than about 1.5mm, as the coasters will start to sit proud of the holder. The models…
20mm dowel rod mount to be used in a wardrobe. Meant to be fixed with an M3 screw
Stand for an Amazon Echo Dot 3rd gen, with a bowl for keys or whatever miscellaneous stuff you might want to store there The peg that attaches the bowl to the stand is quite tight by design because I wanted a press fit. Depending on your…
We needed to attach a 60mm thread to a 25mm hose. Only off the shelf solutions we could find would have needed multiple parts and connections. I'm a bit apprehensive about using a 3D printed part like this in such a critical section of…
Specifically the ASUS ZenScreen MB16AH 15.6" FHD Portable Monitor, but should work for others too
Fair warning: This was a tough print. I was using up old filament, so that probably made it harder than necessary, but still. There are a LOT of overhangs that kept curling up and causing the extruder to collide with the print. I had to…
Our boat has a table that threads into a hole in the cockpit. It probably used to have a cover at some point, but that was lost well before we came along. Enter this thing. It works really well! The loopy bit inside it is for a rope or…
an 80mm hose mount with a vent built in.
Ok, so I'm very new to modeling in general, but specifically to remixing. If you try to slice this at 0.2, the original design will show through. I printed mine in PETG, but only because I wanted it to match the rest of my printer. PLA…
So is the logo on the new macbooks the right way up, or upside down? Some say right way up, because it's the right way, when the macbook is open. I say, that I payed for it, it should be designed for me, and I see it as upside down just…
A stand for the Ayaneo Next that slots into the phone/tablet stand on the Logitech K780, so you can play games that require a mouse and keyboard on the go. Works fine, just be careful when you pick the device up out of it, I somehow…
You could print or buy a full replacement cap, but I quite like the feel of the original. Also, I only wanted the right stick to be longer (for better camera control) but still wanted my sticks to match. This was a serious pain in the…
So our hatches are… ooooooooold. They used to support themselves if we wanted them open just a little bit, but now they need some help. The screw is so we can attach it to the handle, so we don't lose it. Could use some work as you have…
Organize all your mobile devices with this parametric, chainable phone stand . Designed for mobile developers, QA testers, and tech enthusiasts , each unit can be adjusted to fit any phone or device and connected to additional stands to…
To wszystkie aktualnie dostępne wyniki.
