Liczymy pasujące modele…
Box for a balun or unun of your desired configuration wound on a FT240 toroid. Features: M5 bind terminals with winged nuts used to quickly connect or disconnect antenna radials. The ring with 8 holes in the middle of the bottom part is…
How to use: Place your collimator on the jig. Turn on the laser and point it at a distant wall. Rotate the collimator and observe the laser spot. It should ideally not move as the collimator rotates. Adjust the screws on the collimator as…
This antenna uses 12mm copper plumbing pipe as its elements - these should be readily available at any DIY-store. The antenna geometry was optimized in Matlab. It is very well matched to 50Ω without any additional matching device required…
A rope winder for 2mm rope. Originally intended for 2mm arborist throw line.
Dovetail laser pointer bracket for cheap chinese laser pointers. Print out of PLA or PETG BOM: 3x M3x14 screws (exact length is not important) 3x M3 heat set insert 1x laser pointer
Print out of hard TPU, like Flexfill 98A. Can probably be printed out of PET as well, but fitting the VTX into the slot might be hard. Longer M1.5 screws are needed for the VTX, but the VTX can also be just slid into the slot and will…
Tinywhoop canopy with standard 25.5mm mounting holes. Fits nano sized cameras (14mm wide) such as Caddx Baby Ratel, Runcam Nano 4 etc. Fusion360 project included. Weight is about 1.7 g (polycarbonate, 1.1x extrusion multiplier). Not the…
To wszystkie aktualnie dostępne wyniki.
