Liczymy pasujące modele…
I glued folded fabric to the inside of each piece, and snapped them together with the strings between them above the nut. Print Settings: 0.2 layer height 3 Top/Bottom layers 50% infill
A quick block for my tremolo. My sustain block is slightly angled, which may not be the case for other guitars so you should measure the dimensions of the space behind your sustain block and alter accordingly. To install, slightly detune…
Using ikea bedframe slats as the wood. The dimensions of the wood are 15mm x 32mm, who's length can be cut to accommodate the number of pedals you plan to use.
This spacer is meant to increase the airflow into the pc case while allowing the white front panel to stay on. Super quickly modelled and can definitely be improved, but it works for me.
A remix of the GoG Enmey Ripper body initially modelled by Romey83 on thingiverse. Prints well with the nose flat on the build plate and supports. Original creator also has the original models available for those that want to make their…
A standoff for the DeepCool MaCube 110 that allows you to ditch the plastic air-restricting mounting plate. Printed setting don't matter too much, just make sure not to use excessive infill so the peg can slot into the case by bending and…
My Aurora II 114/450 reflector telescope was good for backyard viewing. But I wanted to mess around and explore some astrophotography. Unfortunately, my DSLR was unable to reach focus without a 2x barlow lens, which made it much more…
An insert an cap that adapts an olympic weight plate to an M12 threaded rod that I am using as a counterweight for my CG-2 equatorial telescope mount. This requires two M12 hex nuts to clamp the weight along the counterweight shaft.
0.1mm layer height, 10% infill. Painted with nail polish and sharpies because I lost my paints, Finished with a light clearcoat
An LED growlight I quickly modeled that uses an old 8mm linear rail rod, a 5V LED strip soldered to a 4mm diameter usb cable. The 8mm linear guide rod was salvaged from my old Anet A8 clone. To put it together, cut and place the LED…
To wszystkie aktualnie dostępne wyniki.
