Liczymy pasujące modele…
This is a fan that friction fits onto the collet nut of a Dremel/Craftsmen 395 rotary tool. It blows air over the bit to clear the dust from the cutting area so you can see better. I remixed the original design as I didn't like the…
I remixed one of the gargoyles to fit into the open end of the pipe on my gate. The bottom of the gargoyle is ~29mm is diameter. Easily scales up/down to fit different sizes of pipe.
This is a spice rack which uses 1/4" (6.35mm) dowels. There is a slot on the back side of the bracket so it mounts flush when using a 3M Command Strip. The brackets are narrow so the command strip needs to be cut in half lengthwise. If…
This part allows you to stack wide mouthed mason jars. It was designed specifically for the Ball mason jars so I'm not sure if it works with other brands. The part is split into a top and bottom half, which need to be glued together after…
Lollipop stand for full-sized suckers. Holds 10. It does tip over if all the lollipops are on one side. I mainly wanted it for decoration and occasional use, not as a store stand, although it would work as one if you glued a magnet to the…
This knob/thumbwheel is designed for M3 hex head bolts. Category: Parts
The bumpers are to prevent the bottom of the battery bank from getting scratched up setting it on rough surfaces. They're slightly undersized on purpose to fit snugly and not slide around. The cover prevents dirt intrusion into the ports…
This is a replacement guard for the Central Machinery belt sander. May require a slightly longer screw than for the original guard. Category: Parts
I designed this tool to help crease paper when doing papercrafting or origami. It works much better than trying to use your finger or a bone folder since it doesn't slide across the paper. The only vitamin needed is a bearing, a printable…
This is an adapter to connect the Kenmore Crossover Max vacuum hose to fit a 1.25" attachment. Specifically this was designed and only tested for fit on the "Under Fridge Cleaning Tool Flat Vacuum Attachment" on Amazon , but may fit other…
While the C510 webcam is great if you want to put it on the top of your monitor, it's terrible for sitting on a flat surface, It constantly moves and pivots around unless you weigh it down. So I designed this stand which the folded up…
I've never had any of my batteries short before in my storage case, but due to the connector's hermaphroditic design, there's always that possibility, so I designed this cover which snaps over the connector to protect the exposed pin.…
I found it difficult to adjust my z-axis endstop precisely (fractions of a mm) once it was close. I could only find one other adjustable endstop for opto switches, however it mounted the switch horizontally, which wouldn't work with my…
I designed this after not finding any bike mounts for the belt clip, only the bracelet attachment. There are 4 different models to choose from, depending on the diameter of your handlebars and if you want to put rubber/foam tape between…
This is a replacement funnel for the large Essick pedestal humidifier. I picked up a used one that didn't come with the funnel, so I created my own version. Print it standing up. No supports needed. Category: Household
This thing is a fan mount to cool off a TrackIR 4 sensor. These units get very hot, they're barely touchable where the processor is after they've been on a while. I've lost one unit already (probably to heat) and now that it's out of…
To wszystkie aktualnie dostępne wyniki.
