Liczymy pasujące modele…
Remodeled puck as close as possible. Also adding a STEP file to make it easier for people to remix. v2 has closer dimensions to original, extra holes (for m4 in the future probably?) and deeper holes for inserts/screws
A case for friendlyelec nanopi r3s LTS. Note that lts version is a bit different compared to regular r3s. I've not designed any button pushers or anything since a usecase for me for those is not there. Required 3x m2x8 shcs and 3x…
A model based on idea introduced in https://cults3d.com/en/3d-model/various/reximex-rp-rpa-front-sight but using M3 heat insert and a hex grub screw. After roughly figuring out sight height, unscrew it, put it on a threadlocker and screw…
Since it's a load-bearing (although minor load) and typically inside enclosure ABS is recommended. I've used 4 perimeters, 4 top/bottom layers and 0.2 layer hight
A top with appropriate thread hole to fit citadel painting handle. A small cavity is present on top for poster putty to affix your mini to. How I Designed This OpenSCAD Requires https://github.com/adrianschlatter/threadlib to render…
I felt a bit compelled printing tubes and finding M8 bolts. So instead I've designed an insert which has bearing to decrease spool friction using a pair of 625 and one 624 bearings. Insert goes into existing spool holder turned upside…
This is an upgrade to V-Spooler-X by @FyrbyAdditive. Agreed with him to publish this model. Replaces part of gantry/guide. Requires: 100mm linear rod - 6mm diameter (if you want to be super neat - can be cut flush) 1x LM6UU bearing 2x…
This is version for smart effector and 40x40x10 fan. Needs 4 M2.5x20 screws. I've used brass tubes with 4mm OD from eBay and used drilling jig from https://www.thingiverse.com/thing:2445660 to drill holes. Print Settings Printer: Kossel…
A chassis to fit 5 SBC-s into a 10 inch rack 2 units. Chassis is designed around standard din rail (35mm wide, 7.5 mm deep) as a load bearing. Print 2x ear 4x railHolder up to 5 blanks BOM: 8x heat inserts m3*4mm*5mm 8x M3*5mm FHCS 2x…
Same as original except objects are manifold and slice in Slic3r now. Category: 3D Printer Accessories
A stand/holder for hex screwdrivers set from swisstools (PB-8625.CBB). Print upside down - should print fine without supports
Transport insert (goes between cartridge and air pressure regulator/port) for tesro pa10-2. Should work on all models, pictured with signum. Printed in petg. Two variations, v2 is bit shorter and the one i ended up using
To wszystkie aktualnie dostępne wyniki.
