Liczymy pasujące modele…
I printed with PETG filament, 0.4 mm nozzle, 0.1 mm layer height, and 100% fill. Printing took about 2 hours. Given these parameters, I changed the filament (Orca Slicer) at layer 15.
A TV set-top box shelf for a Samsung Series 6 TV. It's installed in place of a tabletop mount when the TV is wall-mounted. I made two versions, with and without a side rail. A side rail can interfere with the use of a flash drive. There's…
The original impeller broke. I quickly designed a replacement that’s fairly similar. Ideally, this should be printed in ABS, but I didn’t feel like changing the filament spool, so I printed it in PETG instead. If it melts, I’ll reprint it…
I redesigned the panel to accommodate a different voltage converter LM2596S (66 x 36 mm) with a single button. I added the ability to swap out the switch panel and added three switch panels (I had them on hand and was able to measure…
APEK-AS 56 ME Pro Line, 6501 Pro Line, CHAMPION ST553, ST661. Part Number: KCM22B-02-17
An outlet for additional filament tube mounting. Mounts to two tubes or one.
Attention!!! Since I printed the gears using ABS (printing with nylon is practically impossible with a 0.25 mm nozzle, and with a 0.4 mm nozzle, the gear teeth don't turn out as well), there is some shrinkage. There is a gap in the gears,…
Родственник попросил сделать корпус под часы. Собраны из светодиодного дисплея на 4 сегмента (diymore TM1637 LED Module) и ЕСП015, синхронизируются по вайфаю. Может кому пригодится. A relative asked me to make a watch case. It's made from…
I decided to make a simple candybowl (for mints) for work. I used the company logo as the base for the mold. I printed it with PETG plastic in vase mode. The nozzle was 0.8 mm, the wall width was 1.2 mm, and the layer height was 0.24 mm.…
To wszystkie aktualnie dostępne wyniki.
