Liczymy pasujące modele…
This adapter connects a Kärcher hose connector (e.g. from WD-series) to the Dust Commander DLX cyclone. Print Settings: Filament: PETG Infill: 20 % Gyroid Layer Height : 0.3 mm (with variable layer height) 2 Walls (perimeters), 4 Top, 3…
This funnel was created because I was not satisfied with the funnels one could buy here in the stores for kitchen accessoires. All those funnels had long thin outlets with decreasing opening diameters. These long thin outlets are suitable…
This is a simple adapter to use CR2025 batteries in devices made for CR2430 batteries. In the pictures it is shown inside the cap of a Polar Stride running sensor. The adapter in the fotos was printed with the following settings:…
Remixed for index cards of size DIN A8 (inner dimensions: 74.5 x 52.5 x 1.6 mm). To the sides a small pen can be attached (diameter of ring: 6.9 mm). The pen in the photo is a “Online Mini Portemonnaie”. Print setup used: Filament: PETG…
This stand supports the dumbbell for easier loading with plates. It is designed for dumbbells with a grip-diameter of up to 30 mm, a grip-length of at least 125 mm and plates of up to 5 kg. Tested until now with 25 kg with the following…
In the Arduino Starter Kit a base plate (yellow plastic piece in my case) is included to mount the Arduino and the bread board on. But there are no spacers included so that the contacts of the Arduino are touching the plate when it is…
This funnel was created for easy refilling of spice jars of "Fuchs" brand. This funnel is designed with the following goals in mind: Outlet with opening suitable for spice shaker of "Fuchs" brand Inside diameter of outlet is increasing to…
The adhesive pads that came with our Wenko rack did not reliably stick to the surface it was glued on, so I made this hook to use it with Tesa Powerstrips. This worked better on the particular surface but also not reliable. Maybe this…
This remix changes the grommet to have a toroid interior instead of funnels. Also the edges with contact to the filament are more rounded. Drill hole is unchanged.
This drawer inlay was made with Fuchs spice containers in mind. spice containers are supported on two sides to prevent sideways motion gap (sideways) between containers: ~ 15 mm chamfer 4x4 mm at the bottom for drawers with chamfers or…
Drilling holes in the ceiling is not possible where I currently live. So I made this to mount the smoke detector directly to a lamp. The screws should be lubricated a bit, otherwise the friction can be pretty high. Print setup I used:…
To wszystkie aktualnie dostępne wyniki.
