Liczymy pasujące modele…
I did not create the original file. I took a dxf file and cleaned it up a little then created the stl file. Free to share but not to sell. No specific printing setting but I highly advise using ASA or similar filament. Simply attach it…
I made this for my 1998 Astro Van. I'm not sure if it will fit earlier years. I was missing one of the rubber cupholder bottom inserts when i bought it. Print using the most flexible TPU your printer can handle. Category: Other
I just received my LED strobe and couldn't find a mount. I'm cheap and didn't want to pay for the firehouse mount. I couldn't sleep last night so at 3am decided to make my own mount. I made it for my Mini 2 but assume it will fit the…
I was inspired by other pedalboard ends I saw but wanted something with a flat bottom so I could stick pads on the bottom to keep it fro sliding around. This is designed to use the 1/2” x 2-1/2” poplar boards you can by at Home Depot. The…
My friend told me his kid lost one of the trestles to his magic Tracks set. I took measurements and made a (darn close) copy of it. Its the dark gray one in the picture. I didn't put the round nubs on the top of the trestle since it…
My Astro has the barn doors so I don't have rear wipers on the dash. I created this blank as I was going to put an HDMI port there and didn't want to destroy the original. I'm not sure if it will fit the other positions. For fun i put the…
The rubber grommets were disintegrated on my 1998 Astro. I created a model for new ones and printed them using TPU since replacement are crazy expensive. I recently replaced the fan shroud with an aftermarket and had to make the grommet…
I created this to use the existing doghouse bolt and location to mount my phone. You could probably figure out a way to get another mount on there but I use the little round mounts that Quad Lock makes. I highly suggest using ASA or…
To wszystkie aktualnie dostępne wyniki.
