Liczymy pasujące modele…
This is secure and strong mount for Closetmaid ShelfTrack and Rubbermaid FastTrack vertical rails, which attaches into three levels like the Rubbermaid FastTrack shelves. To install, angle the top in first, then bring the mount's inner…
Replacement screw for an incredibly cheap, unbranded umbrella. But I prefer repairing it instead of replacing it. Maybe this oversized M8x1.25 thumbscrew will help fix something else too.
Using this tool, there's no need to balance multiple header rows under the board, or worry about misaligned holes. This design allows for easy and well-aligned soldering of header rows onto ESP32-WROOM D1 Mini boards. The slots on either…
This print allows REI Co-op Flexlite backpacking chairs to sit over sand at the beach, instead of sinking into it. Not sure if this fits any other backpacking chairs, since they seem to have similar shapes and dimensions. The design…
This is a single slot hook mounted tiedown point for Closetmaid ShelfTrack and Rubbermaid FastTrack vertical rails. It works by sliding the longer end up into the rail, pushing the part into the rail's outer face, and then pushing down…
One of these carpet cleats can attach to one of the existing rubber feet of a Yes4All stackable platform, and allow it to sit on carpet without shifting from lateral forces. For FDM printing, I recommend printing on its side with supports…
This is a replacement back stand for Temtop LKC-1000S+ air quality sensor. I broke mine the moment I opened it, just sheared one of the pins right off as I opened its stand. Hadn't even taken a measurement yet. So if you do the same, now…
This attaches to the outlet of the PureZone Mini HEPA filter, and provides a ¼ inch NPT threaded interface. You must tap the NPT threads yourself, since there is only a conical hole modeled for tapping. To assemble, you must remove the…
This is a replacement part for the left ear fork of a Turtle Beach EarForce X11 headset, in case you're still using it 15 years later and yours broke like mine did. For FDM printing, I recommend printing flat with supports. There isn't…
For FDM printing, I recommend orienting with the largest area face on the build plate, with supports on for the twist feature that juts out at 90 degrees. PLA with 20% infill has worked great for me.
For FDM printing, I recommend orienting the part on its edge, so that none of the layer lines provide weak points in the bending direction from putting headphones onto the holder. PLA with 20% infill has worked for me for years now. The…
This design allows HTC Vive users to mount their base stations to the top rail used by Rubbermaid FastTrack shelf systems. To install, you angle the top into the rail, bring the bottom into contact with the wall, and lower the mount onto…
To wszystkie aktualnie dostępne wyniki.
