Liczymy pasujące modele…
Volvo 850 speaker adapter to convert to 13cm (5inch) speaker. If needed drill new holes to position your speaker. Print out of PETG or ASA or ABS or better. Use at least 20% infill and 4 walls.
I made this adapter to fit my headunit better in the new fascia. Should be a snug fit! Printed in PETG (stay away from PLA for car parts!).
Behringer FLOW8 wall mount bracket. Printed in PETG, but any filament should hold. I had to remove the rubber feet! Both models should be layed on the side to print.
Remix of Orange Pi Zero 2 with expansion board. Added a slot for a 30mm fan above the antenna. Also left some space to run wires out from gpio pins besides the fan.
Volvo 850 switch panel replacements with some preconfigured holes
Endoscope mount for Ender 3 / CR-10 Fits a cheap 6mm endoscope from ebay. Clears original BL touch mounts. Print flat side down. Use supports touching buildplate. 0.2 layer height. Printed in PETG, but PLA should also work fine.
Made to fit this USB hub: https://www.aliexpress.com/item/1005008054068671.html?spm=a2g0o.order_list.order_list_main.41.7c091802AWyCrw You need a JSAUX modcase for this to work! Printed in ASA+, but PETG should work fine, maybe even PLA…
I drew inspiration from the model I linked in the remix section Started from scratch for my own switch and made a mount for PTFE tube. The pneumatic fitting has 10mm of PTFE tube sticking out for a better guide. I also made the switch…
Golf 4 1.9TDI 3,5inch sport filter adapter. Print in ASA/ABS or better. (Maybe PETG could work) Fits on original MAF. Has a fitting for vacuum hose. Should fit any 3,5inch (89mm) inside diameter filter.
Simple to print phone mount adapter for 22mm diameter handlebar. It uses an existing phone mount from Aliexpress or Temu which costs around 5€. Just split the model in your slicer. Only one part needs a bit of support (check picture for…
Fits a RPi5 with connector adapter and 2 channel SSD hat. https://www.waveshare.com/wiki/PCIe_TO_2-CH_M.2_HAT+_(B) https://www.waveshare.com/wiki/Pi5-Connector-Adapter All hardware should come with both adapters. Also fits stock cooler.…
Hotone Ampero 2 Stomp box with 1 input and XLR stereo out. Printable withoust support I used two stereo jack to XLR adapter cables(30cm) and an input jack from Thomann. I also used a right angle adapter IEC C14 Male Plug to C5 from…
10 inch rack Archer C54 mount Easy to print. I printed mine out of ASA, but you could use PLA or PETG easily. No supports needed. Print on front face.
To wszystkie aktualnie dostępne wyniki.
